Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Access point 1252AG cannot join the wireless lan controller 2125

i configured the wireless LAN controller with basic configuration in the configurtion guide but the access point 1252AG did not join the controller 2125

i attached the configuration on the WLC

2 REPLIES
Hall of Fame Super Silver

Re: Access point 1252AG cannot join the wireless lan controller

Have you tried to put the AP on the same subnet as the management and ap-managers.  This is one of the easiest ways to make sure the ap joins the wlc.  If the ap still doesn't join, then console into the ap and log the join proccess and post it.

Scott

-Scott
*** Please rate helpful posts ***
Hall of Fame Super Gold

Re: Access point 1252AG cannot join the wireless lan controller

What is your firmware?

Can you provide logs on the WLC and the 1250?

Can you the AP ping the Management IP Address of the WLC?  If yes, console into the AP and in enable mode enter the command "config lwapp ap controller ".  If no, then why not?

638
Views
0
Helpful
2
Replies
CreatePlease to create content