06-21-2010 10:05 AM - edited 07-03-2021 06:54 PM
Hi,
I am planning to implement LAP in my network, (1250 and 1140 series)
I would like to know what is the minimum and maximum Characters can be assigned to an LAP.
Thanks,
06-21-2010 10:11 AM
Normally names can be upto 63 characters...
06-21-2010 10:30 AM
Thanks for your reply,
is there any supporting document on cisco website or its your practical experience ?
06-21-2010 10:12 AM
minimum is 1 i guess.. not sure, i hv not tried..
06-21-2010 10:34 AM
Practical experience.. and also came to know using the below doc..
https://www.cisco.com/en/US/docs/wireless/bridge/1400/12.3_8_JA/configuration/guide/p38adm.html
the doc is for autonomous.. however, if we have the LAP and if we issue the command "debug lwapp/capwap console cli" , "config t" , hostname
06-21-2010 10:35 AM
Practical experience.. and also came to know using the below doc..
https://www.cisco.com/en/US/docs/wireless/bridge/1400/12.3_8_JA/configuration/guide/p38adm.html
the doc is for autonomous.. however, if we have the LAP and if we issue the command "debug lwapp/capwap console cli" , "config t" , hostname
06-21-2010 01:34 PM
Thanks for your reply,
I have read one more document from cisco site,
http://www.cisco.com/en/US/docs/wireless/access_point/12.4_3g_JA/configuration/guide/s43frst.html
here for 1200 series AP they have mentioned "You can enter up to 32 characters for the system name."
thats why I wanted to confirm will LAP support more than 32 characters or not.
I am designing a Wireless for Company, these details are required to complete my decision.
Cheers
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: