I'm using VLAN 2 in my network as management VLAN. All network devices have the management IP address in this VLAN. I have some problems though to connect to 2 access points 1602. I set up VLAN 2 and configure the subinterface Gi0.2 and the bridge group 2. Then, I configure the BVI2 with the managemente IP address, I enable "bridge 2 route ip" and it works. However, when I reload the AP I cannont connect any more to the IP address. If I erase the configuration, reload and paste the previous running-configuration, it works again (until I reload).
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...