Hi all,
I'm using VLAN 2 in my network as management VLAN. All network devices have the management IP address in this VLAN. I have some problems though to connect to 2 access points 1602. I set up VLAN 2 and configure the subinterface Gi0.2 and the bridge group 2. Then, I configure the BVI2 with the managemente IP address, I enable "bridge 2 route ip" and it works. However, when I reload the AP I cannont connect any more to the IP address. If I erase the configuration, reload and paste the previous running-configuration, it works again (until I reload).
Any clue why this happen?
Thanks,
Andres