Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Access point Signal strength

Could someone please tell me how to configure my WLC 2504 to set the associated access points signal strength to maximum?

1 ACCEPTED SOLUTION

Accepted Solutions
Community Member

You can set maximum power

You can set maximum power individually on each AP or you can set them globally to Power Level 1 which is the maximum power level by going to:

Wireless > 802.11b/g/n or 802.11 a/n/ac > RRM > Power Level Assignment Method > Fixed 1

4 REPLIES
Community Member

You can set maximum power

You can set maximum power individually on each AP or you can set them globally to Power Level 1 which is the maximum power level by going to:

Wireless > 802.11b/g/n or 802.11 a/n/ac > RRM > Power Level Assignment Method > Fixed 1

Community Member

thanks for the help

thanks for the help

Please go through-Wireless >

Please go through-

Wireless > 802.11b/g/n or 802.11 a/n/ac > RRM > Power Level Assignment Method > Fixed 1

Community Member

I have the same problem I

I have the same problem I have Access Point Cisco 1602I-T-K9 is set up, but
with a very weak signal, where I set to leave the strongest signal?

962
Views
5
Helpful
4
Replies
CreatePlease to create content