cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
10677
Views
5
Helpful
4
Replies

Access point Signal strength

Maurice Ball
Level 3
Level 3

Could someone please tell me how to configure my WLC 2504 to set the associated access points signal strength to maximum?

1 Accepted Solution

Accepted Solutions

Ashish Chandra
Level 1
Level 1

You can set maximum power individually on each AP or you can set them globally to Power Level 1 which is the maximum power level by going to:

Wireless > 802.11b/g/n or 802.11 a/n/ac > RRM > Power Level Assignment Method > Fixed 1

View solution in original post

4 Replies 4

Ashish Chandra
Level 1
Level 1

You can set maximum power individually on each AP or you can set them globally to Power Level 1 which is the maximum power level by going to:

Wireless > 802.11b/g/n or 802.11 a/n/ac > RRM > Power Level Assignment Method > Fixed 1

thanks for the help

Abhishek Abhishek
Cisco Employee
Cisco Employee

Please go through-

Wireless > 802.11b/g/n or 802.11 a/n/ac > RRM > Power Level Assignment Method > Fixed 1

I have the same problem I have Access Point Cisco 1602I-T-K9 is set up, but
with a very weak signal, where I set to leave the strongest signal?

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: