Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

ACS Appliance setup in Windows 2003 AD envionrment

Looking for information on setting up ACS appliance version 4.1.1.23 in Windows 2003 Active Directory environment. Intention is to authenticate users ( hand-held barcode scanners & few laptops running windows XP pro SP2) with AD. At the moment I'm stuck with certificate issues as appliance is running windows 2000. Please provide any links you may have. Also, Cisco authorized training on this matter is very hard to find in Toronto Area.

Current equipment & configuration:

- ACS appliance 4.1.1.23

- 3 x cisco Aironet 1240AG

- Server Cert from Windows CA imported in to ACS

- AP configured to use ACS for autentication(shared password) - Followed User guides and white papers from this site, but there was no exact match for my network guide so had to take info from quite a few guides.

When laptop attempts to authenticate I get error that no valid certificate was found even though I've imported client cert manually.

Thank you in Advance,

Trbonja

2 REPLIES
Silver

Re: ACS Appliance setup in Windows 2003 AD envionrment

ACS Solution Engines can not authenticate directly against AD. Try this document to properly set up your ACS Remote Server.

http://www.cisco.com/en/US/docs/net_mgmt/cisco_secure_access_control_server_for_solution_engine/4.1/installation/guide/remote_agent/rase41.html

HTH

Steve

New Member

Re: ACS Appliance setup in Windows 2003 AD envionrment

Thank you for reply Steve. Two agents are installed on couple of DC & each is recognized by ACS.

Also a single Active Directory group was mapped to ACS group. This was mentioned in most white papers. Anything else I should check?

regards,

Trbonja

151
Views
0
Helpful
2
Replies