Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Adding a WLAN for Remote Location

Hello everyone,

I have a question about creating a WLAN for a remote location on a 5508 WLC that's housed at our main office.  Attached is a diagram of the connection between the two locations.  My question is, how do I set this up?  Our WLC is at our main office (10.1.x.x) and I was able to get a lightweight AP to join the controller using an IP address from the local subnet of the remote location (10.20.x.x).  However, I want to create a new subnet that will be broadcast at the remote location only and clients will use the local DHCP/DNS server there.  Usually, I create a new interface when I set up a new network but I have to specify a VLAN ID.  Since the VLAN at the remote location is also VLAN 1, how do I go about doing this?  Do I create an untagged interface?  Please help!

 

Regards,

Terence

1 REPLY
Hall of Fame Super Gold

I think you're better off

I think you're better off using H-REAP/FlexConnect.

39
Views
0
Helpful
1
Replies
CreatePlease login to create content