Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

Adding Antenna in WCS for coverage prediction

Can I add a custome based antenna in WCS for coverage prediction?

3 REPLIES
Hall of Fame Super Silver

Re: Adding Antenna in WCS for coverage prediction

What do you mean? The antennas you can choose are only Cisco branded antennas. If they are different manufacture, it will not be in the list. You can try to choose something similar and also set the dbi for the antenna.

http://www.cisco.com/en/US/docs/wireless/wcs/7.0/configuration/guide/7_0maps.html#wp1126390

http://www.cisco.com/en/US/docs/wireless/wcs/7.0/configuration/guide/7_0apcfg.html#wp1095547

Sent from Cisco Technical Support iPhone App

-Scott
*** Please rate helpful posts ***

Re: Adding Antenna in WCS for coverage prediction

Depending on the version of your WCS ...

Go to Configure > Access Point > choose the AP of your choice > under Radio Interface choose 802.11a/n > under Antenna is External Antenna drop down box.

Bronze

Re: Adding Antenna in WCS for coverage prediction

WCS provides the ability to enable or disable the use of specific  antennas. All antennas are enabled by  default. At least one transmitting and one receiving antenna must be   enabled. You cannot disable all transmitting or all receiving antennas at once.

Pease check the below links which may be helpful for you:

Link-1

http://www.cisco.com/en/US/docs/wireless/wcs/7.0/configuration/guide/7_0apcfg.html#wp1095504

223
Views
0
Helpful
3
Replies