01-19-2012 08:51 AM - edited 07-03-2021 09:24 PM
I am putting in a new 5508 controller. I've built the WLANs, activated the wireless, and configured the network for DHCP.
When I add a new 1262 wireless AP to the network, it gets an address from DHCP, but then says it cannot communicate with the controller (it is on the correct vlan/subnet--the same as the controller).
Not sure what I am missing here, and the errors are not telling me much
any advice would be great
Solved! Go to Solution.
01-19-2012 09:01 AM
Along with the time that Scott mentioned what version of code are you running? The 1262's require either 7.0.98 or 7.0.116 depending on the model.
01-19-2012 08:59 AM
Make sure the time is set correctly on the wlc.
Thanks,
Scott Fella
Sent from my iPhone
01-19-2012 09:02 AM
The time is correct on the controller
01-19-2012 09:07 AM
Post the output from the AP when consoled in.
Thanks,
Scott Fella
Sent from my iPhone
01-19-2012 09:01 AM
Along with the time that Scott mentioned what version of code are you running? The 1262's require either 7.0.98 or 7.0.116 depending on the model.
01-19-2012 12:24 PM
It needed a code update to 7.0.98
thanks!
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide