Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Cisco Support Community site will be in read only mode on Dec14, 2017 from 12:01am PST to 11:30am for standard maintenance. Sorry for the inconvenience.

New Member

Adding Wireless APs (1262s) to 5508

I am putting in a new 5508 controller. I've built the WLANs, activated the wireless, and configured the network for DHCP.

When I add a new 1262 wireless AP to the network, it gets an address from DHCP, but then says it cannot communicate with the controller (it is on the correct vlan/subnet--the same as the controller).

Not sure what I am missing here, and the errors are not telling me much

any advice would be great

1 ACCEPTED SOLUTION

Accepted Solutions
Silver

Adding Wireless APs (1262s) to 5508

Along with the time that Scott mentioned what version of code are you running? The 1262's require either 7.0.98 or 7.0.116 depending on the model.

http://www.cisco.com/en/US/docs/wireless/controller/5500/tech_notes/Wireless_Software_Compatibility_Matrix.html#wp41742

5 REPLIES
Hall of Fame Super Silver

Re: Adding Wireless APs (1262s) to 5508

Make sure the time is set correctly on the wlc.

Thanks,

Scott Fella

Sent from my iPhone

-Scott
*** Please rate helpful posts ***
New Member

Adding Wireless APs (1262s) to 5508

The time is correct on the controller

Hall of Fame Super Silver

Re: Adding Wireless APs (1262s) to 5508

Post the output from the AP when consoled in.

Thanks,

Scott Fella

Sent from my iPhone

-Scott
*** Please rate helpful posts ***
Silver

Adding Wireless APs (1262s) to 5508

Along with the time that Scott mentioned what version of code are you running? The 1262's require either 7.0.98 or 7.0.116 depending on the model.

http://www.cisco.com/en/US/docs/wireless/controller/5500/tech_notes/Wireless_Software_Compatibility_Matrix.html#wp41742

New Member

Adding Wireless APs (1262s) to 5508

It needed a code update to 7.0.98

thanks!

446
Views
0
Helpful
5
Replies
CreatePlease to create content