Welcome to Cisco Support Community. We would love to have your feedback.
For an introduction to the new site, click here. And see here for current known issues.
I'm trying to use the address filters on the AP 350 and do not understand the following feature:
"Is MAC Authentication alone sufficient for a client to be fully authenticated?"
I mixes EAP and OPEN AUTHENTICATION, AP AUTHENTICATION AS WELL AS RADIUS authentication. Does anyone have an idea, or used it already?
The explanation on the help is quite confusing as far as me.
Often times complex configuration issues are best addressed in an interactive session with one of our trained technical assistance engineers. While other forum users may be able to help, its often difficult to do so for this type of issue.
To utilize the resources at our Technical Assistance Center, please visit http://www.cisco.com/tac and to open a case with one of our TAC engineers, visit http://www.cisco.com/tac/caseopen
If anyone else in the forum has some advice, please reply to this thread.
Thank you for posting.
MAC addresses are easy to spoof. Using the MAC filter alone would not be secure.