Answering to your first question, I suppose that will not work. I tried this with Ap1242 APs. The 1242 AP cannot operate a bridge in both the radios. The AP1242 is a dual band AP Bridge mode (an infrastructure mode that allows a pair of 1242's to perform Bridging (this is limited to one band .11a or .11b/g). It also supports linking to other Cisco-Aironet devices in Bridge mode such as
In response to your first question, using point to point or multi point is just a matter of how many non-root bridges you have. 1 remote bridge and you have point to point, 2 or more remote bridges and you have multi-point.
The distance is determined by height above all obstructions, power level, noise level and antenna being used. To see what the range would be you should use the wireless calculator on this web site.
As for configuring bridging in the access point, you just need to set it as either a root or non root.
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...