Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Air 1130 cannot stop boot from flash

Hi All,

Air1130 has wrong image in the flash flash:/c350-k9w7-mx.123-8.JA2.bin. I need to delete this image and load a new image. But I cannot access the AP. When I boot, it try to boot from flash and stop over there, the output follows,

Loading "flash:/c350-k9w7-mx.123-8.JA2.bin"...##################################

################################################################################

################################################################################

################################################################################

################################################################################

###########################

File "flash:/c350-k9w7-mx.123-8.JA2.bin" uncompressed and installed, entry point

: 0x3000

executing...

How can I delete this wrong image on the Flash and load the new image in this circumtances.

Thanks,

3 REPLIES
Community Member

Re: Air 1130 cannot stop boot from flash

I tried to stop boot from flash using ESC. It doesnot work. Directly boots into flash and stop at one point. from there no response,.

Thank you,

Siva

Hall of Fame Super Gold

Re: Air 1130 cannot stop boot from flash

Step 1 The static IP address of the PC on which your TFTP server software runs should be between 10.0.0.2 and 10.0.0.30.

Step 2 Make sure that the PC contains the access point image file (such as c1200-k9w7-tar.122-15.JA.tar for a 1200 series access point) in the TFTP server folder and that the TFTP server is activated.

Step 3 Set the timeout value on the TFTP server to 30 seconds.

Step 4 On the PC where the TFTP server is located, perform these steps:

a. Disable any software firewall products, such as Windows firewall, ZoneAlarm firewall, McAffee firewall, or others.

b. Ensure all Windows files are visible. From Windows Explorer, click Tools > Folder Options > View; then uncheck the Hide extensions for known file types check box.

Step 5 Rename the access point image file in the TFTP server folder to c1200-k9w7-tar.default for a 1200 series access point, c1130-k9w7-tar.default for an 1130 series access point, c1240-k9w7-tar.default for a 1240 series access point, and c1250-k9w7-tar.default for a 1250 series access point.

Step 6 Connect the PC to the access point using a Category 5 (CAT5) Ethernet cable.

Step 7 Disconnect power from the access point.

Step 8 Press and hold MODE while you reconnect power to the access point.

Step 9 Hold the MODE button until the status LED turns red (approximately 20 to 30 seconds) and then release.

Step 10 Wait until the access point reboots, as indicated by all LEDs turning green followed by the Status LED blinking green.

Step 11 After the access point reboots, reconfigure it using the GUI or the CLI.

Re: Air 1130 cannot stop boot from flash

545
Views
5
Helpful
3
Replies
CreatePlease to create content