Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

AIR - AP1131AG - E -K9

Hello everyone,

I have AIR - AP1131AG - E -K9 access point and I want to publish second ssid. There is no vlan structures in my local area network. Second ssid will publish same IP address scope as first ssid do. Is it possible to publish second ssid with this settings?

Thanks & Regards

Everyone's tags (4)
3 REPLIES
New Member

AIR - AP1131AG - E -K9

Hello Ekin;

Does it ask you? You can set two broadcast ssid and different vlan, correct? please create/config subinterface and BVI config interface.

Please read:

http://www.cisco.com/en/US/docs/wireless/access_point/12.3_7_JA/configuration/guide/s37ssid.html

Exam:

AP(config)# interface Dot11Radio0.1

AP(config-subif)# encapsulation dot1Q 1 native

AP(config-subif)#bridge group 1

AP(config-subif)# interface FastEthernet0.1

AP(config-subif)#bridge group 1

AP(config-subif)# encapsulation dot1Q 1 native

AP(config-subif)# end

AP# write memory

AP(config)# interface Dot11Radio0.2

AP(config-subif)# encapsulation dot1Q 2

AP(config-subif)#bridge group 2

AP(config-subif)# interface FastEthernet0.2

AP(config-subif)#bridge group 2

AP(config-subif)# encapsulation dot1Q 2

AP(config-subif)# end

AP# write memory

AP(config)# interface Dot11Radio0.3

AP(config-subif)# encapsulation dot1Q 3

AP(config-subif)#bridge group 3

AP(config-subif)# interface FastEthernet0.3

AP(config-subif)#bridge group 3

AP(config-subif)# encapsulation dot1Q 3

AP(config-subif)# end

AP# write memory

Please read: https://supportforums.cisco.com/docs/DOC-14496

New Member

AIR - AP1131AG - E -K9

Hi,

Thank you for sharing your ideas but I want to establish this wifi without any vlan.

Bronze

Re: AIR - AP1131AG - E -K9

Hi , you can configure 2 different ssids on the same radio with no vlans but the secuirty method should be none.

You will not be able to broadcast more than 1 SSID at a time.

Also at the end having 2 ssids on the same subnet and with the  no secuirty would not make sense because at the end it is the same as having just one SSID

Sent from Cisco Technical Support iPhone App

2056
Views
0
Helpful
3
Replies