Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

AIR-LAP1262N-E-K9 fail to boot

hello friends

i have 1262 LAP which is fail to boot and went to rommon mode

here are the logs

ap: boot

Loading ""...: permission denied

Error loading ""

Interrupt within 5 seconds to abort boot process.

Boot process failed...

ap: dir

List of filesystems currently registered:

               flash[0]: (read-write)

              xmodem[1]: (read-only)

                null[2]: (read-write)

ap:

ap: flash_init

Initializing Flash...

flashfs[0]: sector 68, block 169 checksum (0x1aa8 != 0xe2f0)

flashfs[0]: writing to flash handle 0x230932c, device 0, offset 0x1520000, length 0x208: Operation Failed

flashfs[0]: sector ptr: {0xa9, 0x44}

...done Initializing Flash.

how to fix it?

many thanks

Everyone's tags (1)
5 REPLIES
Cisco Employee

AIR-LAP1262N-E-K9 fail to boot

well well

It mens that your IOS image is corrupted and you need to load it again.

The instructions are listed as below:

http://www.cisco.com/en/US/partner/docs/wireless/access_point/12.4_10b_JA/configuration/guide/scg12410b-chap22-trouble.html#wp1048378

---------------------------------------------------------------------------------------------------------------

please make sure to mark the thread as answered upon having correct answer

New Member

AIR-LAP1262N-E-K9 fail to boot

thanks for your reply

is this image i need to upload

ap3g1-rcvk9w8-tar.124-23c.JA5.tar

what is method to upgrade a image on LAP when AP is in rommon mode like ap:   ????

thanks

Bronze

AIR-LAP1262N-E-K9 fail to boot

Hi,

Just so you know the AIR-LAP1262N-E comes preloaded with LWAPP so it can work with a WLC, and the AIR-AP1262N-E comes pre loaded to work in autonomouse mode.

In either case we can convert the unit from IOS to LWAPP and from LWAPP to IOS.

Here is the correct IOS FIle for the 1262, ap3g1-k9w7-tar.124-25d.JA1.tar.

The IOS files are always k9w7 and the LWAPP files are k9w8.

The file you mention above ap3g1-rcvk9w8-tar.124-23c.JA5.tar is the lwapp recovery image.

New Member

AIR-LAP1262N-E-K9 fail to boot

You can do these commands:

   flash_init

   ether_init

   tftp_init

then

Your entry might look like this example:

ap: tar -xtract tftp://192.168.130.222/images/c1310-k9w7-tar.122_15.JA1 flash:


Cisco Employee

AIR-LAP1262N-E-K9 fail to boot

yes thats the one.

Same procedure described in the link i have already forwarded to you

Enjoy

2250
Views
0
Helpful
5
Replies
CreatePlease login to create content