Doing a passive survey is good in certain circumstances but if you were really looking to do a active survey and cannot associate then I would first look at your configuration ... did you set authentication on the AP and if so did you set that same authentication in AirMagnet? Secondly, when doing an active suvey it's alwasy good to start close to the AP and start the survey without moving so that your laptop can associate and authenticate first then proceed. Lastly, if your authentication isn't working then I would set the AP to open authentication and make sure that AirMagnet is setup the same way?
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...