Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Cisco Support Community site will be in read only mode on Dec14, 2017 from 12:01am PST to 11:30am for standard maintenance. Sorry for the inconvenience.

New Member

Aironet 1030 - ALARM state

Hi all

My AP stopped working totally when i power it off & on. It just shows ALARM on the LED. By right when power on first time, it should start flashing searching for WLC, but it is just lights up ALARM LED.

Is there anyway i can reset the AP without the WLC.

Plz advice

1 REPLY

Re: Aironet 1030 - ALARM state

Per the manual that comes with our 1000 series:

"The Red LED can light for about 10-20 seconds when it reboots. If the Red LED comes on and stays on for more than a minute, call TAC"

147
Views
0
Helpful
1
Replies
CreatePlease to create content