Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Aironet 1100 and Cat5k port errdisable ?

Why does the port that an aironet access point is connected to on a Catalyst 5505 with WS-X5012A blades go into Error Disable mode if you disconnnect and reconnect the aironet AP ?

The AP is hard coded for 10Mb/s Half Duplex & the switchports are configured for auto. We cannot hardcode the switchports as the AP's are roaming training devices.

Why does this happen ???

Cheers

mips

1 REPLY
New Member

Re: Aironet 1100 and Cat5k port errdisable ?

This is a well known behaviour, try upgrading the image on the Aironet 1100.

136
Views
0
Helpful
1
Replies
CreatePlease to create content