I received my new CISCO gear including Aironet 1140 AP and Wireless Lan Controller. During the installating of the devices I have run into an issue with getting POE working. For each AP we have an air-pwrinj3 inline power injector. Following the installation guide as far as I can tell with the CAT cabling going from the To Device port on the injector into the Ethernet port on the AP.
The AP does not power on and the Device Status indicator on the injector remains off. The injector it's self has power and Power Status indicator is solid green.
Have tried this using multiple APs and multiple poe injectors and have run out of ideas. The APs power up fine when getting POE from the Wireless LAN Controller device or when connecting power to the AP directly from the supplied power supply.
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...