The access point/bridge power injector contains an embedded 10/100baseT switch, which is unconfigurable. The ports on the switch are set for auto-speed and auto-duplex, and auto-MDIX. Port 0 on the switch is used for the coaxial link to the bridge; port 1 on the switch is used for the RJ-45 jack on the power injector. The other switch ports are unused.
The speed and duplex settings on the bridge FastEthernet0 interface only apply to the link between the bridge port and port 0 in the power injector switch. They are entirely independent of the speed/duplex used on the RJ-45 port on the power injector. Therefore, for best performance, the bridge FastEthernet must always be set to auto speed and auto duplex. This setting results in 100 Mbps, full duplex used on the link between the bridge and power injector.
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...