Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

aironet 1242AG GUI

hi,

i just received my aironet 1242AG. I configured the fastethernet 0 ip address. I tried to get 1242AG GUI through fastethernet 0. But I didn't managed to get in the GUI. Is there another setting that I must do before I can access 1242AG GUI ??

Oh ya, I'm new in wireless field. :)

1 ACCEPTED SOLUTION

Accepted Solutions
New Member

Re: aironet 1242AG GUI

I think you configure the ip addr in bvi int and not not fa, if you are configuring this from factory default. I am also assuming this is IOS based wap and not LWAPP.

1 REPLY
New Member

Re: aironet 1242AG GUI

I think you configure the ip addr in bvi int and not not fa, if you are configuring this from factory default. I am also assuming this is IOS based wap and not LWAPP.

397
Views
0
Helpful
1
Replies