I configured the bvi interface with a fixed ip address and i am able to ping it and configure it via telnet/ssh. But when i try to configure it via Web Interface it authenticates with my local Usr Credentials and allows me to login, and then if i want to do anything else once i am connected it keeps asking the Usr credentials again and never authenticates. Could someone help me with this ?
I didn't configure too much on it. Just created some username and password and a secret password. And when i connected using Web interface using my usrname and psw it is only allowing to level 1. And if i connect using no usrname and my secret psw it allows me to level 15.
Is there anyway i can tell it to allow to level 15 with my usrname and psw?
IntroductionHow to use the Wireless LAN Controller Configuration Analyzer (WLCCA)
Javier Contreras is a Senior Tech Lead for the Wireless Business Unit in Cisco, with over 2 decades of experi...
< PRE >
(#)For this reason being that : - application that doesn't use multicast, sends one copy of each packet ( data unit of traffic at layer 3 ) to each client (" who seeks the traffic ).- application that does use multicast, sends ...
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...