Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Aironet 1250 with 2x 2.4Ghz Antenna

I need to upgrade a 1230 to the new Aironet 1250 at a location. I have only 2 external antennas at that location.

I understand that you still can run 802.11n with 2 antennas.

But I can not find anywhere in WLC 5508 v7.2 that I can disable the middle nut (C)

Please advise.                  

Everyone's tags (4)
1 ACCEPTED SOLUTION

Accepted Solutions

Aironet 1250 with 2x 2.4Ghz Antenna

the middle nut is a Rx only, so you wouldn't need to disable it really.

But if you go to Wireless > 802.11a (on the left) > then pick the AP you want to configure, you can uncheck that box.  This is a per AP config, so could take you a while.

HTH,
Steve

-----------------------------------------
Please remember to rate useful posts, and mark questions as answered

HTH, Steve ------------------------------------------------------------------------------------------------ Please remember to rate useful posts, and mark questions as answered
3 REPLIES

Aironet 1250 with 2x 2.4Ghz Antenna

the middle nut is a Rx only, so you wouldn't need to disable it really.

But if you go to Wireless > 802.11a (on the left) > then pick the AP you want to configure, you can uncheck that box.  This is a per AP config, so could take you a while.

HTH,
Steve

-----------------------------------------
Please remember to rate useful posts, and mark questions as answered

HTH, Steve ------------------------------------------------------------------------------------------------ Please remember to rate useful posts, and mark questions as answered
New Member

Aironet 1250 with 2x 2.4Ghz Antenna

It works, thank you

Hall of Fame Super Silver

Re: Aironet 1250 with 2x 2.4Ghz Antenna

When the ap is joined to the wlc, you can click on the blue arrow on the right side of the ap listing that says configure. IIRC, it there where you can set what ports you will use.

Thanks,

Scott Fella

Sent from my iPhone

-Scott
*** Please rate helpful posts ***
296
Views
0
Helpful
3
Replies
CreatePlease to create content