I have two 1310s. One set as a root-bridge with wireless clients, another as a non-root bridge with wireless clients. The wireless side of things is working fine, but I'm having trouble when I try to connect a windows work station to the non-root bridge via ethernet. I'm getting an IP address from the router attached to the root bridge via DHCP, and I am able to connect to the configuration page of both 1310 APs, but I'm not getting any internet connectivity. Have I misunderstood what 'non-root bridge with wireless clients' means? If not, is there an obvious problem which might cause the wireless clients to work fine, but interfere with a wired client? Thanks.
It sounds like you have a gateway issue. You can obviously get to all devices on the subnet you attached to but cannot get past that one. Check your DHCP scope to make sure you have the correct default gateway assigned.
It's good to know that this is how it is supposed to work. The thing that has me scratching my head is that the wireless clients are working fine from this bridge--it is only the client hooked up to the ethernet interface that is not getting out.
I'll take a look at the gateway settings and see what I can find. I appreciate the tip.
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...