For some reason I was not able to post in the Wireless community.
I have two 1532 APs that I am trying to use to bridge the LAN between 2 buildings. The Dot11 radios both show that they are in a reset/down state and I cannot get them to come up. I have rebooted the APs and do not have physical access to them to console in. I have attached the configs and the show ver. Any thoughts?
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...