I'm trying to configure a new Aironet2600 wireless access point with the web configuration utility. I only need a simple single SSID, no VLANs, and want to use WPA/WPA2 PSK security. Is there a way to configure the device this way in the web config? If not is there a basic config walkthru to use the IOS CLI? I have a basic understanding of CLI but it has been years since I've used it.
Keep in mind, if you want to get 802.11n speeds (anything above 54Mbps), you have to use WPA2/AES (or open authentication). So I would stick with WPA2/AES, unless it is really necessary to have WPA/TKIP (if your clients are not supporting WPA2/AES)
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...