09-10-2010 11:58 AM - edited 07-03-2021 07:10 PM
How do I connect to a 3500 to see the spectrum analysis? The manual says to download version 4.0 of the Cisco Spectrum Expert software but the latest verion is 3.3.52. What am I missing?
I want to get the most out of these new APs !!
Thanks,
Andrew
Solved! Go to Solution.
10-05-2010 11:48 AM
It is still Beta code. Not only do you need the Beta code, but a key
as well. After you have that installed, you log into your controller and
change the mode of your AP to SE-Connect and reboot the AP.
Then you go to the AP, copy another "key" from the AP and also
gather the IP address if it is DHCP.
You paste the key into your Spectrum Expert that is running on your
laptop, along with the IP address of the AP.
Then you can remotely see your spectrum.
I have done this before since I tested a 3500 for a few weeks before
sending it back to Cisco.
I'm impressed.. it is definately a nice feature.
10-05-2010 07:47 AM
Hi Andrew
Have you already found something? I also search for version 4.
10-05-2010 11:48 AM
It is still Beta code. Not only do you need the Beta code, but a key
as well. After you have that installed, you log into your controller and
change the mode of your AP to SE-Connect and reboot the AP.
Then you go to the AP, copy another "key" from the AP and also
gather the IP address if it is DHCP.
You paste the key into your Spectrum Expert that is running on your
laptop, along with the IP address of the AP.
Then you can remotely see your spectrum.
I have done this before since I tested a 3500 for a few weeks before
sending it back to Cisco.
I'm impressed.. it is definately a nice feature.
10-07-2010 11:08 AM
Thanks dennehy.
We'll just have to wait until they release it!
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: