Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Aironet 3502 only shows wireless N

I bought a used Aironet 3502 (air-cap3502i-a-k9) on craigslist last week and the seller said it was set up for autonomous mode. It has ap3g1-k9w7-tar.124-25d.JA, which does allow it to run without a controller. I know it's not the latest version, but without a service contract I'm unable to access the latest firmware. When I go into the web management console, it only shows wireless N, without letting me enable A/G. The product sheet shows it should do A/G/N - is this just a byproduct of putting the autonomous ios on a 3502, or am I missing a setting somewhere to enable it? I've attached a SS of the tap showing the interface incase it helps clarify my issue. Any help would be greatly appreciated, thanks in advance!

Clipboard01.jpg

3 REPLIES
Hall of Fame Super Gold

Aironet 3502 only shows wireless N

Do you see that it says "2.4 Ghz" and "5.0 Ghz"?  That's your A and B, respectively. 

New Member

Aironet 3502 only shows wireless N

Well then, egg on my face. Thanks for the quick response. I'll look through online documentation to try to get my devices connected - I assumed it wasn't transmitting on G since none of my devices can see it and I don't have any N capable receivers. The radios are enabled, but maybe I'm missing something else. Thanks again.

Hall of Fame Super Gold

Aironet 3502 only shows wireless N

If you want to enable "N" then ...

1.  Use OPEN or no authentication; or

2.  Use WPA2/PSK; and

3.  Enable WMM.

509
Views
0
Helpful
3
Replies