Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Aironet Autonomous 1252 CLI command 802.11n disable

hi, I am using Aironet Autonomous 1252 AP. The version used is: Cisco IOS Software, C1260 Software (AP3G1-K9W7-M), Version 12.4(25d)JA1, RELEASE SOFTWARE (fc1) I want to disable 802.11n on 2.4GHz interface. Please tell the CLI command to do this. Thanks in advance. uv.
1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Hi, It is present in WLC but

Hi,

 

It is present in WLC but in Autonomous AP , I think you would have to disable data rates used by 802.11n which are called MCS rates. It is the same way , we disable 802.11b without disabling 802.11g.

(config)#int d0
(config-if)#no speed m0-7
(config-if)#no speed m8-15

 

**Please rate helpful posts**

4 REPLIES
Cisco Employee

Hi, It is present in WLC but

Hi,

 

It is present in WLC but in Autonomous AP , I think you would have to disable data rates used by 802.11n which are called MCS rates. It is the same way , we disable 802.11b without disabling 802.11g.

(config)#int d0
(config-if)#no speed m0-7
(config-if)#no speed m8-15

 

**Please rate helpful posts**

VIP Purple

Why you want to disable 802

Why you want to disable 802.11n data rates ?

There are few other ways as well. For 802.11n you should have following

1. WMM enable

2. either Open Authentication or WPA2/AES

So if you are not using 1 & 2 both, you won't get 802.11n data rates. Refer this

https://supportforums.cisco.com/discussion/12078656/aironet-ap-1252-how-use-80211g-only

 

HTH

Rasika

**** Pls rate all useful responses ****

Cisco Employee

Hi ,Yeah. But normally people

Hi ,

Yeah. But normally people use wpa2 only for security and if you want to disable 802.11n for this , 802.11n rates should be disabled so that clients connect as b/g. Alternatively , go to the wireless adapter of the client and disable 802.11n so that client use b/g only.

Regards

Dhiresh

**Please rate helpful posts**

New Member

thanks yadav.

thanks yadav.
472
Views
0
Helpful
4
Replies
CreatePlease login to create content