I have a few Aironet Power injector LR2's that are new and I'm trying to config for the first time. Im using the console cable with no luck - Com1 9600 8 none 1 none???? Very strange that it is not connecting on any of them - even tried a different cable. I get no display through hyperterm except maybe for a few symbols/chars. Tried the Ethernet port, checked dhcp server and did not show the device. Any advice is greatly appreciated.
If it is the 1310 power injector as Rob has linked above, then that power injector requires the 1310 to be attached to it for configuration. Basically, the power injector provides the ports (network/console) to the 1310 which only has the dual coax going to it.
If you have a 1310 attached and you are not able to configure it via network or the console cable then you really have a problem. Otherwise, just know the power injector require no configuration to interface with the AP it was designed for.
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...