I have a question about access rate of the 1310G. Per the guideline, the bridge can get the rate up to 54Mbps, but in fact, I found the rate will never beyond 28Mbps. Why this happened? Is there something wrong with my configuration?
I found following words on CCO and I don't understand it. Can anybody give me some hints? thanks a lot.
Data rates of up to 54 Mbps can be enabled for point-to-point links up to 1.5 miles in length, with throughput in excess of 22 Mbps.
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...