The statement you make is true if you are using any vlans internal to the BBSM. There is an issue that is being worked related to vlans and the polling of the bridge mib in these devices. If you have no vlans a mix of vxworks and IOS Aps should be just fine.
I have never seen an issue with the APs running IOS. I would recommend using the packet version of the Dlls when you set them in network elements. No there is no bug at this point. We having been discussing it internally to see if it is a configuration issue or a bug.
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...