Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

allow only MCS data rates and disable others

Hi,

i have 1260 AP (Autonomous) and i want the clients to connect only at 5GHz MCS rates (802.11n) and i dont want clients connecting at 802.11a data rates. i tried to do this from AP GUI but it says i have to enable at least one data rate from 11a. Please advise how to acheive this.

Thanks

1 REPLY

allow only MCS data rates and disable others

you have to have a 'legacy' rate enabled at this time.  What I would do, is disable all rates except for 54Mbps.

HTH,
Steve

------------------------------------------------------------------------------------------------
Please remember to rate useful posts, and mark questions as answered

HTH, Steve ------------------------------------------------------------------------------------------------ Please remember to rate useful posts, and mark questions as answered
488
Views
0
Helpful
1
Replies
CreatePlease to create content