You want them to be dissconnected if the tunnel fails. Part of auto anchor is so that your traffic gets tunneled to an anchor WLC. So if the tunnel or the anchor WLC is not available to the foreign WLC which is your inside WLC, then devices should not be able to authenticate. You will see the SSID, but best practice is to map your guest WLAN to a blake-hole or null interface on the foreign WLC. If you have the WLAN mapped to your management or any other valid interfaces, then if the tunnel breaks, your guest users will end up on the interface you specify on the foreign WLC WLAN.
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...