- Cisco AP1121G (with IOS 12.2(13)JA1) that connects in the wired side to a HP Procurve switch 2524.
- 3 VLANs: Management (20), Staff (100) and Guest (102)
- 1 PC connected to the wired network
- Wireless users that connect to the AP using one of two SSIDs: Staff (802.1x authentication) or Guest (Guest mode). Depending of SSID thye are mapped to the correpondent VLAN (Staff or Guest).
If the wireless user connects to the Guest network (no encryption) can contact with the PC in wired network (VLAN Guest). They are in the same IP subnet.
If the wireless user connects to the Staff network (authentication EAP/TTLS and WEP encryption) can't contact with de PC in wired network (the VLAN of PC was changed to Staff). They are in the same IP subnet.
If I change the authentication mode of SSID Staff to open and no encryption all works ok, so the problem is when the channel is encrypted.
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...
I have created a Powershell script to automatically add a Wireless Guest
User on Cisco WLCs. (tested on 2500 Series) The script should be
completely self explanatory. Prerequisites: Powershell SNMP Module
(Install-Module -Name SNMP) SNMP Write Access to y...