AP-1131AG: 2 VLANs/SSIDs, switch port configuration?

[pizzov]

We're setting up a (seemingly) simple deployment of some APs, and want 2 SSIDs...one will have Pre-Shared WEP and one will be open and broadcast (with access-lists on the router). My question is how to set up the switch port to match my AP, in order for it to pass both VLANs (in this case I've setup WLAN100=VLAN100 and WLAN101=VLAN101)...Do I have to configure trunking on that switchport? Thanks for any links or answers on this!!!

[Rob Huffman]

Hi Vince,

Here is a great doc that goes over this concept in detail. You will need to configure Trunking on the switchport. Have a look at what yours might look like;

switchport mode trunk

switchport trunk encapsulation dot1q

switchport trunk native vlan 1

switchport trunk allowed vlan 1,100,101

From this excellent doc;

Using VLANs with Cisco Aironet Wireless Equipment

http://www.cisco.com/en/US/products/hw/wireless/ps4570/products_configuration_example09186a00801d0815.shtml#clic2935xl

Hope this helps!

Rob