03-23-2006 10:13 AM - edited 07-04-2021 11:50 AM
Hi.
Got an AP1200 - I have a blue cable console connection. I hold the mode button down, reboot, and get a console session. It logs the interfaces for a bit, but then stops and never gives a console prompt. I've tried break, ctl-c, etc...
Any suggestions.
03-23-2006 11:06 AM
Check if you use these port settings on your hyperterm:
Speed: 9600 bits per second (bps)
Data bits: 8
Stop bits: 1
Parity: None
Flow Control: Xon/Xoff
03-31-2006 12:24 PM
Hi, Holding the MODE button down on a reboot resets the AP to factory defaults.
If held for 20 to 30 secs it takes you into the Automatic IOS recovery routine for putting a new IOS image on a AP after a fail. (If held for 20-30 Seconds and middle amber light on front of AP turns RED)
If you want to just get to the prompt set your hyperterminal settings to
Speed: 9600 bits per second (bps)
Data bits: 8
Parity: None
Stop bits: 1
Flow Control: none
and reboot as normal with no buttons pressed.
Hope this helps
George
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: