Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

AP 1231 Configuration

I always have this problem when I console to the AP1200 to start initial configuration. I see it boot up on the terminal, but when i press enter to get started, nothing comes up on th eterminal.

So I usually connect it to the network, allowing it to obtain a DHCP address and the access it with that IP address.

unfortunately this is not working now with a new AP I am setting up. It gets an IP address and I can ping it, but cannot telnet or web browse to that IP address to configure the AP.

Basically I cannot access the AP for configuration. Can someone help

  • Getting Started with Wireless
3 REPLIES
Bronze

Re: AP 1231 Configuration

what happens if you reset it to default?

I would be interested in seeing what the vty 0-4 and vty 5-15 settings are but since you can't get in it...

New Member

Re: AP 1231 Configuration

i have reset it to default several times by poering off the AP, holding down the button and then powering it back up and then releasing the mode button.

i am unable to access it via console and telnet so i dont know what the vty setting are

New Member

Re: AP 1231 Configuration

HI,

for reset the ap press mode button for 20 second then supply the power to the ap.

after that u can use console for access the ap via hyper terminal.

thanx

567
Views
0
Helpful
3
Replies
This widget could not be displayed.