Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

AP 1240 to non Cisco

We have some non Cisco AP's that I am trying to configure a Cisco AP 1240 to associate with.

The radio will not come out of "disabled"

Antenna is connected and I have done the basic config, there is no security set up at all on the existing untit.

What are the basic setup parameters for the raido to assiciate with the other side?

are there any debugs I could look at?

1 REPLY
Cisco Employee

Re: AP 1240 to non Cisco

Hello Rich,

AP 1240s will not link up with any 3rd party devices.

To make a bridge link with the 1240 another Cisco make AP would be needed.

Regards,

Aaron

136
Views
0
Helpful
1
Replies
CreatePlease to create content