Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

AP 1242AG configuration

Hi,

I would like to set up the following,

1. set trunk on the AP and LAN switch

2. configure the client obtain ip address from my wired network (vlan 5, ip 192.168.10.0/24)

3. configure the management vlan 6, ip address 10.10.10.1

The wireless clients will only need access to the internet over the wired network.

Could someone please tell me will this work?

Thanks,

4 REPLIES
New Member

Re: AP 1242AG configuration

Hi,

I use this setup as you described on several APs, so it will work without problems.

Best regards,

Peter

New Member

Re: AP 1242AG configuration

I have problem obtain ip address from my dhcp server from the network. Is there anything need to do on the AP in order for this to work.

Thanks,

Cisco Employee

Re: AP 1242AG configuration

Hi ,

can you send me the output of "debug dhcp message enable" from the controller

and run - config

regards

Seema

Green

Re: AP 1242AG configuration

The management VLAN will be the Native VLAN.

To get DHCP addresses to the non-native VLANs, you need to have some Layer 3 device (router or L3 switch) to move the traffic.

This is usually something like "IP-HELPER" on the router interface closest to the client that points to the DHCP server's address.

It should work fine. This is a fairly standard configuraion.

Good Luck

Scott

187
Views
0
Helpful
4
Replies