Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

AP 1310 and other devices

I would like to connect a AP 1310 to a Orinoco ROR.

I configure the Orinoco ROR as AP and the AP 1310 as Non-Root Bridge, the same SSID, all it's find, but the don't connect.

On the 1310 console i have this message:

Interface Dot11Radio0, cannot associate: No Response.

If i look the channel, it's the same as the orinoco, but they can connect, any idea or suggestions.

Thank's

1 REPLY
Green

Re: AP 1310 and other devices

Bridge and AP are incompatible modes.

Bridge modes are proprietary to the manufacturer. AP modes are standards (802.11b/g/a)

You may be able to get connection by making the bridge a repeater. However, it is likely to reduce your throughput.

Good Luck

Scott

144
Views
0
Helpful
1
Replies
CreatePlease to create content