Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

AP 350 Series Routing

Is there a way to use the wireless signal obtained by the access point (in this case a repeater) and route it to a wired network or the ethernet port on the access point itself? I know there is a routing option under "Services" on the Access Point but I wanted to make sure this was possible before I made any configurations.

Thank you,

David

kil.5@nd.edu

1 REPLY
Cisco Employee

Re: AP 350 Series Routing

In case of access point acting as a "Repeater" ethernet port of that "Repeater" will be disabled..So You can't communicate with the wired LAN on Repeater over the wireless link.

256
Views
0
Helpful
1
Replies
CreatePlease to create content