I'm using an Aironet 350 AP with 11.21 firmware and tring to apply an IPX filter on the radio side of the AP. I created the IPX filter using 0x8137 and 0x8138 ipx protocol and set the disposition to block, but when I apply the filter to TX and RX on the radio side of the AP I loose all communications on the radio side of the AP including IP. I also have a 2nd AP with firmware 11.03 and when I create the same filter for IPX it doesn't block any communications. It woks as if no filters were ever applied.
Does anyone have any ideas on what I'm doing wrong?
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...