Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

AP's cannot join controller while it is restarted

Hi ,

I'm using WLC 2106 and 1130 AP's

They're working perfectly, but when I restart the WLC ( while AP's are on, because they have their on power supply ), they cannot join the controller afterwards

Then i need to manualy restart also AP's and after that they join controller.

It's strange because they all have their own static ip addreses , and the MGMT interface address of the WLC is on the same subnet

So is there aby solution ?

It's not easy to restart AP's all the time somewhere on the ceiling ; )

thanks

pet

3 REPLIES
Hall of Fame Super Gold

Re: AP's cannot join controller while it is restarted

Depends on the firmware.

New Member

Re: AP's cannot join controller while it is restarted

thank you for your answer

WLC: Software Version                 5.2.193.0

AP-s IOS: 12.4(18a)JA2

Hall of Fame Super Gold

Re: AP's cannot join controller while it is restarted

Cisco's been recommending everyone to stay away from the 5.X and 6.X codes.  Please upgrade to the 7.X code.

252
Views
5
Helpful
3
Replies
CreatePlease to create content