I have our new WiSM installed and setup. WE can access the WiSM with no issues. Latest code is running on the WiSM/AP's. An AP will connect and show up in the WiSM about after about 2-3 mins the ap will disconnect and go back into discovery mode. This results in an endless loop. We have a 4402 installed as well and have had no problems. The errors we see on the WiSM are below:
Thu May 11 10:33:11 2006 [ERROR] spam_lrad.c 1799: AP 00:15:2c:48:4e:a0 associated. Last AP failure was due to Link Failure
Thu May 11 10:32:56 2006 [ERROR] spam_l2.c 677: Max retransmissions reached on AP 00:15:2C:48:4E:A0 (CONFIGURE_COMMAND
Thu May 11 10:32:56 2006 Previous message occurred 4 times
Thu May 11 10:27:35 2006 [ERROR] spam_lrad.c 1799: AP 00:15:2c:48:4e:a0 associated. Last AP failure was due to Link Failure
Thu May 11 10:27:17 2006 [ERROR] spam_l2.c 677: Max retransmissions reached on AP 00:15:2C:48:4E:A0 (CONFIGURE_COMMAND
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...