08-28-2002 06:06 PM - edited 07-04-2021 11:23 PM
I read up on Cisco's site that you can alter the 350
Series Bridge to be an Access Point. I own the "rugged"
350 Series Access Point, which largely resembles
the multifunction 350 series bridge, and was wondering
if there was some way to make it a bridge.
Thank you,
David
08-28-2002 09:26 PM
You can configure the 350 series bridge to act as "Access Point" but not the reverse..In other words Access Point can't be configured/chaged as a "bridge".
To make bridge as access point, you do not need to alter the hardware, it can be achived just by configuration.
09-06-2002 12:13 PM
tepatel, wrote that the 350 AP can not be used as a bridge (ie 350AP to 350AP), what I want to do is show on figure 1 of the following web page. Do I have to have one 350bridge and 1 350ap or can two 350AP be configured to accomplish the same thing. thx in advance.
http://www.cisco.com/warp/public/cc/pd/witc/ao350ap/prodlit/a350b_ds.htm
regards,
paul
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: