Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

ap:

Hi,

I am a new comer about wireless.I have a problem concerning configuring the ap(1200 series).I have upgraded the ios to a new version and I needed to delete the earlier version to that.After, I have reloaded the device and this prompt is appeared "ap:" so I would like to take out this problem.

Thanks for your assistance.

regards

miradoo

1 ACCEPTED SOLUTION

Accepted Solutions
New Member

Re: ap:

This should help. Look in the recovering from a failure section.

http://www.cisco.com/en/US/products/hw/wireless/ps430/products_tech_note09186a008019fea0.shtml

4 REPLIES
New Member

Re: ap:

What version are you going too, and from? The prompt if it's "AP>" might mean you've lost the running config.

New Member

Re: ap:

Hi,

c1200-k9w7-mx.123-4.JA is the earlier version and the last is c1200-k9w7-tar.123-8.JA.tar that i have done.

The prompt appeared is "ap:"(after reloading), is it rommon mode? I don' t know how to go out of the problem.

I don' t know the commands and the process to do.

So thanks for your assistance.

regards

miradoo

New Member

Re: ap:

This should help. Look in the recovering from a failure section.

http://www.cisco.com/en/US/products/hw/wireless/ps430/products_tech_note09186a008019fea0.shtml

New Member

Re: ap:

Hi,

Thanks a lot for your assistance. I found the solution in the link that you

have given.(reloading the AP by using the mode button has resolved the prompt "ap:" problem).

regards.

miradoo

158
Views
5
Helpful
4
Replies
CreatePlease to create content