AP1121G, cannot access after convert to autonomous mode
successfully downloaded IOS via tftp server to convert the LWAPP to autonomous mode but I cannot access the AP.
I set my station to 10.0.0.5 and continous pinging to 10.0.0.1 but never response by AP. no luck even power cycle and reset (press mode button for 2 seconds while power cycle). I got 'Device no responding' message when I run IPSU.
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...