Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

AP1131 multiple SSID issue

Hello,

Very new to Cisco wireless, trying to figure this out.

I have an ASA that will be handling the VLAN traffic.

VLAN1 = default internal VLAN.

VLAN10 = guest VLAN.

On my AP1131 I want to have "Staff" SSID associated with VLAN1,

and "Guest" SSID associated with VLAN10.

Interfaces 6 & 7 on the ASA are PoE so I think I'm good on that.  I have those two ports on the ASA set as trunks with Vlan1 as native.

My biggest pain right now is that I can't seem to get "Guest" and "Staff" broadcasting at the same time!

I don't really need the "A" radio, so I'm just trying to get the two SSID's broadcasting on the "G" radio.

I'm configuring via the GUI, but frequently looking back at the CLI.

Is this a common issue?  Something that someone can point to a common mistake?

Attached is running-config; though I'm still very much playing with it.

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Red

Re: AP1131 multiple SSID issue

2 REPLIES
Hall of Fame Super Red

Re: AP1131 multiple SSID issue

New Member

Re: AP1131 multiple SSID issue

Thanks Rob,

Sorry for the delay in rating

324
Views
0
Helpful
2
Replies
CreatePlease login to create content